Reference · Dating

EIA date codes and manufacturer codes

Almost every original component in an Ampeg carries a code stamped by the company that made it: two or three digits identifying the manufacturer, then the year and the week of production. Read them and you can date an amplifier built before Ampeg used serial numbers at all.

How the code works

Shortly after the Second World War, American electronic component manufacturers began stamping a semi-standardised code into the parts they produced, administered by the Electronic Industries Association. The code contained information about the maker and the date of production, and it was applied to potentiometers, transformers, capacitors, tubes and speakers.

The code usually consists of six or seven digits, such as 137634. In that example:

  • 137 is the EIA code for the manufacturer — in this case CTS.
  • 6 is the year. Two digits are not used, so it could be 1956, 1966 or 1976. The model, the cosmetics and the other components settle which.
  • 34 is the week of the year, so the 34th week.

Some manufacturers used two digits for the maker code and others three, which is why the same code can be six or seven digits long. Parts do not always carry EIA codes at all, especially during the late 1940s and early 1950s, and replacement parts carry their own manufacture date rather than the date of the amplifier.

Read every code you can find

A single date code tells you when that one part was made. Ampeg did not necessarily use components in the order they arrived, so the useful figure is the latest date code you can find on original parts: the amplifier cannot be older than its newest original component.

Manufacturer codes found in Ampegs

Speakers

Manufacturer EIA code
Jensen220
CTS (Chicago Telephone Supply)137
Eminence67
Quam270
Rola285
Altec391
Electro Voice649

Capacitors

Manufacturer EIA code
Pyramid472
Cornell-Dubilier34

Transformers

Manufacturer EIA code
Acrosound878
Stancor138
Electrical Windings682
Todd Electric Co.926
Standard Electric Products668

Potentiometers

Manufacturer EIA code
CTS137
Stackpole304

Ampeg's own numbering

Where Ampeg bought a part to its own drawing, the part number on the component is an Ampeg factory number rather than an EIA code. A four-page Ampeg factory parts list from June 1978 survives, and it is the best reference for matching those numbers to parts. It is on the schematics page.

Note that some Ampeg part numbers changed in the mid-1970s, so a part number that does not appear in the 1978 list may still be correct for an earlier amplifier.


Codes change

The EIA reassigned and extended manufacturer codes over the decades, and a handful of companies were bought and absorbed while keeping their code. Where a code is ambiguous, the physical part — its shape, its markings and the era it belongs to — is the better guide.