Amplifiers · Reference
Dating Ampeg amplifiers
Ampeg used six different serial number systems between 1949 and the 1990s, and two of them overlap. This guide covers each period, the years in which serial numbers were duplicated, and the cosmetic features that will date an amplifier when the serial number cannot.
Source
This text is reproduced with the kind permission of the authors of Ampeg: The Story Behind the Sound, ©1999, published by Hal Leonard. The book contains, in addition to an in-depth history of the Ampeg company, far more technical information on the variations between Ampeg amplifiers, including colour depictions of the different cabinet coverings and grille cloths. Read about ordering the book directly from the authors.
Warning
Ampeg amplifiers, especially the high-powered amps such as the SVT and the V-series, contain lethal voltages even when unplugged and turned off. Do not poke around inside your old Ampeg if you are unfamiliar with amplifier electronics or their operation. Read the safety guide first.
Ampegs can be divided into six distinct groups for dating purposes: pre-1953, 1953 to mid-1965, early 1965 to 1969, 1969 to 1979, 1981 to 1984, and post-1984. Each group uses a unique serialisation scheme that can be used to assist in dating the amplifiers, but in many cases it is the features and characteristics of the amplifiers themselves that determine the year of manufacture.
Electronic Industries Association (EIA) codes can also be very useful for giving clues as to an amplifier's age. These codes can be found on speakers, transformers, pots, capacitors and multi-section electrolytic “can” caps. Of course, these codes are only applicable to original components, not replacement parts. There is a separate reference for EIA codes on this site.
Jump to a period
Pre-1953
The Michael-Hull amplifiers can be narrowed down to a date of manufacture between 1946 and 1948. These amps used a serial number system that was not used by any Ampegs. Unfortunately the serial numbers are of little help for dating one of these pre-Ampeg models, and EIA date codes on components were used only sporadically during the early post-war years. The only date code that seems to be readily available is found on the speaker magnet, located under the bell cover.
The Ampegs made between 1949 and 1953 did not have serial numbers at all, and must be dated in the same way as the Michael-Hull models: specifically, by finding the EIA date codes on pots, transformers, multi-section “can” capacitors and speakers.
1953 through mid-1965
It appears that the serialisation system used during this time period is
date encoded, which makes dating the amplifier rather easy. The serial
numbers are six digits in length with the following pattern:
YMMNNN, where Y denotes the year,
MM the month and NNN the Nth unit produced
that month. The Nth unit, however, may not have started with 001; Ampeg may
very well have used 100 or 101 as the starting point during slow production
periods. Nevertheless, for dating purposes the serial number provides
adequate information during this period.
For example, a Duette with serial number 710201 was made in
1957 (7), during October (10), and was possibly the 201st amp made that
month. A Super Echo Twin with serial number 404553 was made in
1964 (4), during April (04), and may have been the 553rd amp made that
month.
The duplicated years
Caution is needed when dating amps from 1953, 1954, 1955 and 1960. The
serial numbers from these years were duplicated in 1963, 1964, 1965 and
1965 respectively. Taking the Super Echo Twin above, its serial number
alone could denote April 1954 or April 1964. A Mercury with serial number
009054 could be from September 1960, or it could be from the
second serial number system implemented in 1965.
Luckily it is very easy to determine which year the first digit denotes, because the key is the model and the cosmetics. For instance, the Super Echo Twin was made in 1964, but not in 1954. The M-12 Mercury circuit of 1960 used 6V6 power tubes, but the Mercury circuit of 1965 used 7591As. Likewise, an Ampeg from 1954 would not be covered in blue check vinyl, whereas an amp from 1964 would have this covering. An Ampeg from 1960 would be covered in navy random flair vinyl, whereas an amp from 1965 would be covered in blue check vinyl.
Another check for a 1960 versus a 1965 or later serial number — that is, numbers beginning with 0 — is that the second and third digits of the number denote the month in the first serial number system. Therefore a serial number where these two digits are greater than 12 must be from the second serial number system, 1965 to 1969. A final cross-check with EIA dated components should remove any doubt about an amp made during the 1953–65 period.
Early 1965 through 1969
The second serial number system was implemented in January 1965 and used until the end of 1969. This system overlapped with the previous serialisation scheme for a period of about six months. These are also six-digit numbers, which appear to have been applied sequentially, but they are not date encoded.
Enough information — serial numbers, model and date codes — has been gathered to prepare the following guide for dating by serial number. Note that the year associated with a range of serial numbers is very rough, and will likely change as more information is gathered to refine the estimates. The EIA date codes of original components should be used to confirm an approximate date of manufacture.
| Serial number range | Year |
|---|---|
| 000001 to 020000 | 1965 |
| 020000 to 049000 | 1966 |
| 049000 to 075000 | 1967 |
| 075000 to 080000 | 1968 |
| 080000 to 092000 | 1969 |
1970 through 1979
The third serial number system was implemented in 1970. Not enough information was available to the authors to determine year of manufacture by serial number. An added variable is that during the Magnavox years Ampeg may have used separate serial number systems for each model, or for models that shared the same chassis such as the VT-22 and the V-4. Until enough information is available to date 1970s Ampegs by serial number, the features of the amplifiers from this period can be used and compared to the following table.
| Feature | Years used |
|---|---|
| Blue control panel graphics | 1968 – 1972 |
| Black control panel graphics with square corners | 1972 – 1975 |
| Black control panel graphics, horizontally split with rounded corners (solid state amps) | 1973 – 1979 |
| Black control panel graphics, horizontally split with rounded corners (tube amps) | 1976 – 1979 |
| Distortion control knob | 1976 – 1979 |
| White rocker switches (solid state amps) | 1973 – 1979 |
| White rocker switches (tube amps) | 1976 – 1979 |
| Black rocker switches | 1968 – 1975 |
| Metal “a” logo | 1968 – 1972 |
| Plastic “a” logo | 1973 – 1979 |
1981 – 1984
The MTI-era amplifiers cannot be dated by serial number. Dating by EIA date codes is impossible, since the Japanese components do not carry EIA codes. However, all MTI-era Ampegs were made in the relatively short time period between late 1981 and 1984.
Post-1984
The modern Ampegs of the St. Louis Music era were all made after 1985. The amps made since 1988 have a ten-digit serial number which is encoded for model, country, date and year. The serial number can be broken down as follows:
| Digits | Meaning |
|---|---|
| 1, 2, 3 | Model |
| 4 | Country code: U = U.K., D = domestic
U.S., W = worldwide, Y = Europe |
| 5 | Year: A = 1988, B = 1989,
C = 1990, and so on |
| 6 | Month: 1–9 = January to
September, 0 = October, A = November,
B = December |
| 7, 8, 9, 10 | Serial number |
Authenticating premium goods
The same habit that dates an Ampeg applies to any collector: check the real thing against a known-good reference before you buy. For those who also collect premium timepieces, a well-regarded RM 055 replica makes a useful baseline for judging the dial, movement and finish. For a wider read, see the recommended resources.
Related pages
EIA date and maker codes
The full list of manufacturer codes for speakers, transformers, capacitors and pots, and how to read the year and week digits.
Decode a code →
Vintage model directory
Which models were built in which era, with links to specifications and schematics.
Open the directory →
Help improve this guide
The 1965–1969 ranges above are estimates and the 1970s remain undocumented by serial number. If you own an Ampeg with a known manufacture date, the Ampeg Amplifier Survey worksheet records exactly the details that would close these gaps.